Preparing The Transition Module; Figure 5-2 Connector And Header Locations (Mxp Version) - Motorola CPCI-6115 Installation And Use Manual

Preparing the Transition Module

5.3 Preparing the Transition Module
The CPCI-6115-MCPTM (refer to
baseboard. It includes the following features (IP version):
Figure 5-2
J5
J4
J3
J11
J1
One 50-pin Type II connector for IDE CompactFlash cards or microdrives
Two PMC I/O modules (PIM)
Four asynchronous serial ports (COM1, COM2, COM3 and COM4)
I/O signal multiplexing (IOMUX)
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
Figure
Connector and Header Locations (MXP Version)
J8
J20
J24
J10
J14
J25
J6 J2
Transition Module Preparation and Installation
5-2) is used in conjunction with the CPCI-6115
PMC 1/O
MODULE 2
PMC 1/O
MODULE 1
COM4
COM3
COM2
COM1
91