Setting Switches And Jumpers; Table 2-5 Cpci-6115 Jumper Map - Motorola CPCI-6115 Installation And Use Manual

Setting Switches and Jumpers

2.5.2 Setting Switches and Jumpers
Figure 2-2 on page 35
and LED indicators on the CPCI-6115. Use this figure to help identify the approximate location
of the jumpers on the CPCI-6115. There are seven manually configured headers on the
baseboard. They are described in the following table:

Table 2-5 CPCI-6115 Jumper Map

Reference
J6
J9
J10
J15
J20
J25
J99
SW2
Damage of the Product
Setting/resetting the switches during operation can cause damage of the product.
Check and change switch settings before you install the product.
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
illustrates the placement of the switches, jumper headers, connectors
Function
Bus Mode Select
Header
Stand-Alone Operation
Header
Flash Boot Bank Select
Header
+/-12 V Present Header
Safe Start ENV Header
SROM Initialization
Enable Header
Flash Bank A Write
Protect Header
Manual Geographic
Address -
Hardware Preparation and Installation
Comment
Jumper pins 1-2 for 60x mode
Jumper pins 2-3 for MPX mode
Jumper pins 1-2 for Stand-Alone operation (no CPCI bus)
No jumper or jumper pins 1-2 for Bank A (32 MB)
Jumper pins 2-3 for Bank B (8 MB)
Jumper pins 1-2 allows board operation without +/- 12 V
power
No jumper or jumper pins 1-2 for normal ENV settings
Jumper pins 2-3 for safe ENV settings
Jumper pins 1-2 to enable SROM init
No jumper or jumper pins 2-3 to disable SROM init
Jumper pins 1-2 to enable Bank A Flash Write
No jumper to disable Flash Writes
OFF (default) - GA from CompactPCI backplane
ON - generate address locally
37