Table of Contents
Advertisement
Safety Notes
Board products are tested in a representative system to show compliance with the
above mentioned requirements. A proper installation in a compliant system will maintain
the required performance. Use only shielded cables when connecting peripherals to
assure that appropriate radio frequency emissions compliance is maintained.
Operation
Damage of the Product
Surface of the Product
High humidity and condensation on the product surface causes short circuits.
Do not operate the product outside the specified environmental limits. Make sure the
product is completely dry and there is no moisture on any surface before applying
power.
Do not operate the product below 0°C.
Overheating and Damage of the Product
Operating the product without forced air cooling may lead to overheating and thus
damage of the product.
When operating the product, make sure that forced air cooling is available in the shelf.
Configuration Switches/Jumpers
Malfunction of the Product
Switches marked as "Reserved" might carry production-related functions and can cause
the product to malfunction if their setting is changed.
Do not change settings of switches marked as "reserved".
Damage of the Product
Setting/resetting the switches during operation can cause damage of the product.
Check and change switch settings before you install the product.
Installation
Personal Injury or Death
This product operates with dangerous voltages that can cause injury or death.
To prevent serious injury or death from dangerous voltages use extreme caution when
handling, testing, and adjusting this equipment and its components.
Damage of the Product and Additional Devices and Modules
Incorrect installation or removal of additional devices or modules may damage the
product or the additional devices or modules.
Before installing or removing additional devices or modules, read the respective
documentation.
18
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
Advertisement
Table of Contents
