J25, Srom Initialization Enable Header; J99, Flash Bank A Programming Enable Header; Figure 2-9 Jumper Setting For J25; Figure 2-10 Jumper Setting For J99 - Motorola CPCI-6115 Installation And Use Manual

J25, SROM Initialization Enable Header

2.5.8 J25, SROM Initialization Enable Header
A 3-pin header is used to enable or disable the SROM initialization. A jumper placed between
pins 1 and 2 enables the device initialization via the I
between pins 2 and 3 disables the initialization sequence.
Figure 2-9
2.5.9

J99, Flash Bank A Programming Enable Header

To protect the contents of Flash Bank A a 2-pin header is used to enable or disable the
programming of Flash Bank A. A jumper across pins 1 and 2 enables writes to array blocks,
programming data, or configuring lock-bits. No jumper installed disables all Flash Bank A
programming.

Figure 2-10 Jumper Setting for J99

CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
Jumper Setting for J25
Hardware Preparation and Installation
2
C SROM. No jumper or a jumper placed
41