Unpacking And Inspecting The Rtm; Preparing The Transition Module; Serial Ports 1 And 2 - Motorola CPCI-6020 Installation And Use Manual

Unpacking and Inspecting the RTM

7.3 Unpacking and Inspecting the RTM
Read all notices and cautions prior to unpacking the product.
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten their life.
Before touching the AMC or electronic components, make sure that you are working
in an ESD-safe environment.
Shipment Inspection
To inspect the shipment, perform the following steps:
1. Verify that you have received all items of your shipment.
2. Check for damage and report any damage or differences to customer service.
3. Remove the desiccant bag shipped together with the board and dispose of it
according to your country's legislation.
The product is thoroughly inspected before shipment. If any damage occurred during
transportation or any items are missing, contact customer service immediately.
7.4

Preparing the Transition Module

Before installing the CPCI-6020-MCPTM-01, read these sections for important information on
module configuration and operations.
7.4.1

Serial Ports 1 and 2

The CPCI-6020 provides two 16550 compatible asynchronous serial interfaces: COM1 and
COM2. The COM1 port signals are wired to the front panel RJ-45 connector, but it may
optionally be wired to the backplane via J5 instead. The COM2 port is wired to the J5 connector
only.
COM1 is routed to an RJ-45 connector located at the rear panel of the CPCI-6020-MCPTM-01.
COM2 can be accessed by a planar 9-pin header on the transition module. The COM2 signals
are also wired to the PMC I/O connector for possible access through PMC I/O module.
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Transition Module Preparation and Installation
131