Figure 5-9 Installing The Pim - Motorola CPCI-6115 Installation And Use Manual

Transition Module Preparation and Installation
6. Slide the face plate (front bezel) of the PIM module into the front panel opening from
behind and pace the PIM module on top of the transition module, aligned with the
appropriate two PIM connectors (P0 and P4). The two connectors on the underside
of the PIM module should then connect smoothly with the corresponding connectors
on the transition module (J10 and J14). Refer to the following figure for proper
screw/board alignment.
Figure 5-9
7. Insert the four short Phillips screws, provided with the PIM, through the holes on the
bottom side of the transition module into the PIM front bezel and rear standoffs.
Tighten the screws.
8. With the CPCI-6115-MCPTM in the correct vertical position that matches the pin
positioning of the backplane, carefully slide the transition module into the
appropriate slot and seat tightly into the backplane.
9. Secure in place with the screws provided, making good contact with the transverse
mounting rails to minimize RF emissions.
10.Replace the chassis or system cover(s), reconnect the system to the AC or DC
power source, and turn the equipment power on, or if hot-swapping, you may now
install the CPCI-6115.
112
Installing the PIM
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
PIM Alignment
Installing the PIM