J95, Front Panel 10/100/1000 Megabits/S Ethernet Connector; Compactpci J1/J2 Connectors; Table 3-3 10/100/1000 Megabit/S Ethernet Connector, J95 - Motorola CPCI-6115 Installation And Use Manual

J95, Front Panel 10/100/1000 Megabits/s Ethernet Connector

Table 3-2 COM1 Pin Assignments, J19 (continued)
Pin #
2
3
4
5
6
7
8
3.5.2 J95, Front Panel 10/100/1000 Megabits/s Ethernet Connector
The CPCI-6115 has one front panel 10/100/1000 megabit/s Gigabit Ethernet connector. It is an
industry standard RJ-45 connector with the following pin assignments:

Table 3-3 10/100/1000 Megabit/s Ethernet Connector, J95

Pin #
1
2
3
4
5
6
7
MDIO3-
3.5.3

CompactPCI J1/J2 Connectors

The CPCI-6115 CPU board implements a 64-bit CompactPCI interface on connectors J1 and
J2. J1 is a 110 pin AMP Z-pack 2mm hard metric type A connector with either +3.3 V or +5 V
signaling. J2 is a 110 pin AMP Z-pack 2mm hard metric type B connector. Each of these
connectors conform to the CompactPCI specification. The pinout for connectors J1 and J2 are
implemented as defined in the CompactPCI specification for a 64-bit peripheral slot board. Note
that no reserved or bussed reserved pins are used by CPCI-6115.
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
Signal
RTS
GNDC
TXD
RXD
GNDC
CTS
DTR
1000 Megabit/S
MDIO0+
MDIO0-
MDIO1+
MDIO2+
MDIO2-
MDIO1-
MDIO3+
8
Controls, LEDs, and Connectors
Direction
OUTPUT
N/A
OUTPUT
INPUT
N/A
INPUT
OUTPUT
10/100 Megabit/S
TD+
TD-
RD+
Not Used
Not Used
RD-
Not Used
Not Used
53