J6, Bus Mode Selection; Figure 2-3 Switch And Jumper Locations; Figure 2-4 Jumper Setting For J6 - Motorola CPCI-6115 Installation And Use Manual

Hardware Preparation and Installation
Figure 2-3
SW1
2.5.3

J6, Bus Mode Selection

A three-pin header is located on the board to select the correct bus mode operation (60x or
MPX). No jumper or a jumper between pins 2 and 3 allows the board to be in MPX mode. A
jumper placed between pins 1 and 2 enables 60x mode.
Figure 2-4
38
Switch and Jumper Locations
J9
J6
U22
U32
J98
Jumper Setting for J6
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
J17
J16 J99
J10 J15
SW2
J25
J20
U36
J6, Bus Mode Selection