Parking Brake Switch (Int'l Model) - Polaris 2014 RZR XP 1000 Service Manual

3. Test the transmission switch continuity readings for
each gear position and compare to the specification
table below.
RESISTANCE VALUE
GEAR
WHEN MEASURED AT
POSITION
SWITCH TERMINALS A AND B
HIGH
LOW
NEU
REV
PARK
24 Ω
75 Ω
160 Ω
300 Ω
620 Ω
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.

Parking Brake Switch (INT'L Model)

The parking brake switch is located within the parking
brake lever. Remove the rubber boot covering the
parking brake lever to locate the internally mounted
switch.
The switch remains in the "open" position when the park
brake lever is not applied.
When the parking brake lever is applied, the switch
makes contact and sends voltage to the ECU to
illuminate "BRAKE" in the instrument cluster rider
information display area (see "Park Brake Indicator").
NOTE: If the parking brake is applied the ECU will
rev limit the engine at 1500 RPM until the parking
brake is released. This feature has been added to
prevent drive-away with the parking brake applied.
Testing The Parking Brake Switch
1. Disconnect the harness connector at the parking
brake switch (Orange/Red and Red/Blue wires).
ELECTRICAL
10
10.17