Polaris 2014 RZR XP 1000 Service Manual page 427

ELECTRICAL
Instrument Cluster Pinouts
FUNCTION
CAN High
CAN Low
Switched Power (Vdc)
Constant Power (Vdc)
Ground
High Beam Input
Fuel Level Sensor
Ambient Air Temperature
International Models Only
Turn Signal Input, LH
Turn Signal Input, RH
Instrument Cluster Removal
NOTE: Do not allow alcohol or petroleum products
to come in contact with the instrument cluster lens.
1. Disconnect the wire harness connector from the
back side of the instrument cluster.
10.12
2. Push the instrument cluster (Item 3) out from the
back side of the dash while securely holding the
dash (Item 1) and rubber mount (Item 2).
PIN
1
2
3
NOTE: Do not remove the rubber mount from
the dash panel. Only remove the rubber mount if
4
necessary. The bezel (Item 4) is a snap-on
assembly and is a serviceable part.
5
8
Instrument Cluster Installation
11
1. Spray a soap and water mixture onto the outer
15
surface area of the instrument cluster. This will help
the instrument cluster slide into the rubber mount
more easily.
6
7
2. Be sure the rubber mount inside the dash is fully
installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash.
3. Hold the dash securely and insert the instrument
cluster into the dash. Twist the instrument cluster
gently in a clockwise motion to properly seat the
instrument cluster into the rubber mount. Apply
pressure on the bezel while pressing down on the
instrument cluster.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.