Transmission Removal - Polaris 2014 RZR XP 1000 Service Manual

3. If adjustment is required, loosen the lower jam nut
(Item 4) and pull the cable out of the mount (Item 3)
to move the upper jam nut (Item 5).
4. Adjust the shift cable so there is the same amount of
cable travel when shifting slightly past HIGH gear
and PARK.
5. Thread the upper or lower jam nut as required to
obtain proper cable adjustment.
NOTE: This procedure may require a few
attempts to obtain the proper adjustment.
6. Once the proper adjustment is obtained, place the
shift cable and upper jam nut into the mount. Tighten
the lower jam nut against the mount.
7. Start engine and shift through all gears to ensure the
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
TRANSMISSION

TRANSMISSION REMOVAL

CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this
procedure. Always wear eye protection.
1. Remove the seats, console cover and engine service
panel (see Chapter 5).
2. Disconnect the (-) negative battery cable from the
battery.
3. Remove the rear bumper and cargo box as an
assembly (see Chapter 5).
4. Remove the air box assembly (see Chapter 4 "ECT
Sensor Replacement").
5. Raise and support the vehicle.
6. Remove the prop shaft from the transmission output
shaft (see Chapter 7).
7. Remove rear wheels from the vehicle.
8. If internal transmission repair is required, drain the
transmission lubricant (see Chapter 2).
9. Remove the lower mounting bolt from the left rear
shock. Swing shock outward.
10. Remove the outer clutch cover, drive belt, drive
clutch, driven clutch, inner clutch cover and clutch
outlet duct (see Chapter 6).
NOTE: Be sure to use the correct Drive Clutch
Puller (PN 2872085) to prevent damage to
crankshaft.
8
8.5