Polaris 2014 RZR XP 1000 Service Manual page 176

8. Carefully lift the fuel pump out of the fuel tank. As the
fuel pump assembly is being removed, be aware of
float arm and pump pre-filter. Hold the float arm to
the pump body as you lift and tilt the pump to ensure
that the float arm is not bent when removed from the
tank.
9. Transfer old fuel pump to a suitable container
capable of safely holding fuel. The fuel pump will
retain some fuel.
10. Inspect the inside of the fuel tank for debris (may
require flashlight and mirror). If debris like mud or
sand is present, fuel tank should be flushed and
cleaned out prior to installation of new fuel pump
assembly.
NOTE: It is recommended to remove the fuel
tank from the vehicle and rinse it with a small
amount of clean fuel. Do not use water or any
other chemicals to remove debris.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
ELECTRONIC FUEL INJECTION
11. Remove new fuel pump assembly (Item 5) , gasket
(Item 6) and PFA nut (Item 7) from packaging. Use
care not to bend float arm (Item 8) during un-
packaging. Do not lift or carry fuel pump assembly by
the float arm.
12. Use cleaning wipes provided to clean fuel tank
surface and threads (Item 9). Remove all debris,
grease and oil. Allow surfaces to dry completely.
13. Install new PFA gasket onto fuel pump assembly
using care not to damage gasket or bend float arm.
14. Install fuel pump into fuel tank, hold float arm to the
pump body and tilt assembly to ensure float arm
does not get caught or bent during installation.
15. Gently push down on fuel pump flange ensuring
flange is centered.
4
4.27