Polaris 2014 RZR XP 1000 Service Manual page 170

7. Hold a shop towel over the fuel line fitting and
remove the fuel supply line (Item 5) from the fuel rail.
8. Remove tie strap retaining the injector harness leads
to the fuel rail. Remove the two screws (Item 6) that
mount the fuel rail to the throttle body using a 5 mm
Allen wrench.
9. Carefully pull up on the fuel rail (Item 7) and injectors
and remove them from the throttle body as an
assembly. Take care not to damage the fuel injector
ends during removal.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
ELECTRONIC FUEL INJECTION
10. Pull out on the fuel injector retaining clip and pull the
injector out of the fuel rail. Repeat on the other
injector if removal is necessary.
11. Upon installation of the new fuel injectors, lightly
lubricate the injector O-rings to aid installation.
12. Install the new injector (s) into the fuel rail and
reinstall the retaining clip.
NOTE: Be sure the retaining clip is positioned
on the injector and fuel rail as shown above.
13. Thoroughly clean the area around the fuel injector
ports on the throttle body.
14. Lightly lubricate the injector O-rings and reinstall the
fuel rail / injector assembly into the throttle body.
4
4.21