Etc Replacement; Pedal Position Sensor (Pps); Operation Overview; Location - Polaris 2014 RZR XP 1000 Service Manual

ETC Replacement

1. Remove the cargo box access panel.
2. Remove wire harness from the ETC(Item 1).
3. Remove the four bolts retaining the ETC housing to
intake plenum.
4. Remove the ETC housing and gasket from intake
plenum.
5. Reverse these steps for installation. Torque the ETC
housing retaining bolts and intake boot clamp to
specification.
ETC Housing Retaining Bolts:
7 ft-lb (10 Nm)
Intake Boot Clamp:
35 in-lb (4 Nm)
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
ELECTRONIC FUEL INJECTION

PEDAL POSITION SENSOR (PPS)

Operation Overview

NOTE: DO NOT attempt to service the PPS. The PPS
is a non-serviceable component and can only be
tested using Digital Wrench®. If the PPS is faulty, the
entire throttle pedal assembly must be replaced.
Mounted to the throttle pedal assembly, the PPS acts as
a throttle position sensor. The PPS provides throttle
pedal position to the Electronic Control Unit (ECU) to
increase or decrease engine RPM using the Electronic
Throttle Control (ETC). The PPS is the primary input
used to control engine speed during vehicle operation.

Location

The ETC switch (Item 1) is located in the drivers foot
control area, mounted on the top of the throttle pedal
assembly.

PPS Test

The PPS can be tested utilizing Digital Wrench® by
verifying that throttle position readout varies as the pedal
is pressed. Reference the Data Display section and be
sure Throttle Position is displayed. With the ignition key
on for at least 15 seconds and engine not running, the
Throttle Position will read approximately 9.6% when the
pedal is released. With the pedal fully depressed, the
Throttle Position will vary depending on what gear you
have selected.
• High/Neutral/Park/Invalid ≈ 70%.
• Low ≈ 60%
• Reverse ≈ 32%
4
4.33