Trailing Arm Spherical Bearing Replacement - Polaris 2014 RZR XP 1000 Service Manual

WARNING
Upon rear trailing arm installation, test vehicle at low
speeds before putting into service.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
BODY / STEERING / SUSPENSION
Trailing Arm Spherical Bearing
Replacement
1. Remove trailing arm (see "REAR TRAILING ARM").
2. Remove bushings and O-rings.
3. Remove snap ring (Item 1) that retains the spherical
bearing.
4. Properly support the trailing arm and press the
spherical bearing out of trailing arm casting.
5. Be sure to only press on outer most surface of
bearing race, do not press on the center spherical
bearing.
6. Inspect trailing arm bearing housing for wear or
damage. Replace trailing arm if damaged.
7. Press in new bearing until fully seated into trailing
arm casting.
8. Install new snap ring, O-rings (not required) and
bushings.
© Copyright 2013 Polaris Industries Inc.
5
5.43