Clutch Assembly - Polaris 2014 RZR XP 1000 Service Manual

CLUTCHING
14. Install sheave face down on puller.
15. Install new bushing on installation tool (Item 2) and
install assembly into sheave.
16. Install left hand thread nut (C) onto puller rod and
hand tighten against installation tool.
17. Turn clutch sheave counterclockwise, making sure
bushing is drawn straight into bore. Continue until
bushing is seated.
18. Remove nut (C) from puller rod and set aside.
19. Remove installation tool and clutch sheave from
puller.
6.26

Clutch Assembly

1. Install a new bearing onto the clutch shaft using an
arbor press. Once bearing is fully seated, install a
new snap ring.
2. Install the shaft and bearing assembly into the outer
sheave.
NOTE: Press only on the outer race of the
bearing during installation to prevent damaging
the bearing.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.