Tiger JKT-S10U Operating Instructions Manual page 26

How to reheat oatmeal
Note
● Oatmeal will end up being dry if reheated under
any of the following conditions.
• The oatmeal is reheated without adding water
or milk.
• The volume of oatmeal is below the minimum
required volume (1 cup).
• The oatmeal is reheated 3 times or more.
1
Stir the cooked oatmeal.
● You can add some water or milk to the cooked
oatmeal and reheat it.
Note
● When adding water or milk, add it immediately
after cooking. Otherwise, the temperature will
decrease and the oatmeal may not be reheated.
• Maximum cooking amount when adding
some water or
1.0 L type: 5.5 scale for "Plain"
1.8 L type: 8 scale for "Plain"
2
Make sure that the
Keep Warm lamp is
blinking.
• Reheating is not available if the [Cancel]
key is pressed after the oatmeal has been
cooked.
26 26
milk to reheat oatmeal
Blinks
3
Press the [Start/Rinse-
free] key.
The Start lamp will blink and
reheating will start.
The remaining time will be
displayed and an alarm (3 long
beeps) will sound when the
operation is completed.
Note
● Reheating is not available if the oatmeal is too
cold (131˚F [55˚C] or lower as a guideline). In this
case, a repeated beeping alarm will sound.
4
Stir the heated oatmeal well and
even it out in the inner pot.
Blinks