Tiger JKT-S10U Operating Instructions Manual page 23

Note
● The Timer function is not available in the following
cases.
• When the "Quick", "Synchro-Cooking", "Mixed",
"Bread" or "Slow Cook" menu is selected
• When the preset time is less than that indicated
in the following table (The times in the table
below also apply to rinse-free rice.)
Menu
Plain
Ultra
Jasmine
Brown
Porridge
Oatmeal
(Steel cut)
• When "0:00" is blinking on the display
● If the Keep Warm lamp is on, press the [Cancel]
key to turn off the lamp. (The Timer function is not
available while the Keep Warm lamp is on.)
● If you do not operate the rice cooker within about
30 seconds after pressing the [Timer] key, an
alarm (3 beeps) will sound.
● If the [Timer] or [Start/Rinse-free] key is pressed
while the rice cooker is in a state where the Timer
function is not available, an alarm (3 beeps) will
sound.
5
Use the [Hour] and
[Min] keys to set the
desired completion
time.
Press the [Hour] key to change the set time
in 1-hour increments. Press the [Min] key to
change that time in 10-minute increments.
Hold down the corresponding key to change
the time more rapidly.
Blinks
• The time is displayed in a 12-hour format.
Note
● Do not set the timer to more than 12 hours, as it
may result in spoiled rice.
● Check whether "AM" or "PM" currently displayed.
Minimum preset time
1 h 5 min
1 h 30 min
45 min
1 h 30 min
Cooking time + 1 min
55 min
6
Press the [Start/Rinse-
free] key once.
When cooking rinse-
free rice, press the key
twice.
The Timer lamp will turn on and the Timer
function is set.
• Rinse-free rice can be cooked under the
"Plain", "Ultra", and "Porridge" menus.
For normal cooking
When you selected the "Plain" menu, a one-
short, one-long beep alarm will sound. In
other menus, only a one-beep alarm will
sound.
On
When cooking rinse-free rice
"Rinse-free" appears on the display.
When you selected the "Plain" menu, a
one-short, one-long, another one-short
beep alarm will sound. In other menus, a
one-long, one-short beep alarm will sound.
• If you make a mistake or otherwise want to
reset the timer, press the [Cancel] key and
repeat the procedure from step
On
On
On
2
on p.22.
23 23