Service Mode Operation; Service Mode Map; Service Mode - Canon imagePROGRAF iPF5000 Series Service Manual

7.1 Service Mode

7.1.1 Service Mode Operation

a) How to enter the Service mode
Enter the Service mode following the procedure below.
1) Turn off the printer.
2) Turn on the printer while holding down the [Paper Source] button and [Information] button.
* Keep pressing the above buttons until "Initializing" appears on the display.
3) "S" is displayed in the upper right corner of the display showing the version.
4) After display of "Online", pressing the [Menu] button displays the SERVICE MODE top menu and the MESSAGE LED flashes.
* The Service mode is added to the options in the Main menu. The Service mode can be entered even in the error status (when an error message is shown on the
display) by turning the power off and then using the above key operation.
b) How to exit the Service mode
Turn off the printer.
c) Key operation in the service mode
- Selecting menus and parameters: [
- Going to the next lower-level menu: [
- Going to the next higher-level menu: [
- Determining a selected menu or parameter: [OK] button

7.1.2 Service Mode Map

The hierarchy of menus and parameters in the Service mode is shown below.
] or [ ] button
] button
] key
System Setup
SERVICE MODE
DISPLAY
PRINT INF
Test Print
SYSTEM
HEAD
INK
WARING
ERROR
INK CHECK
(I/O DISPLAY)
YES
NO
S/N
TYPE
LF TYPE
TMP
SIZE LF
SIZE CR
S/N R
S/N L
LOT R
LOT L
BK
MBK
C
M
Y
PC
PM
GY
PGY
R
G
B
1
20
1
20
Y,PC,C,PGY,GY,MBK,PM,M,BK,R,G,B
F-7-1
Chapter 7
0013-2121
0013-2119
7-1