Canon imagePROGRAF iPF5000 Series Service Manual page 91

(3) Grasaping the carrying handles[1] on the left and right side of the bottom,place the printer on a level place such as a table.
(4) Remove all cushioning materials and tape from the printer and accessories.
(5) Install the IEEE1394 Board(option).
(6) Open the top cover,raise the carriage shaft belt stopper[1],and then pull it forward to remove.(Keep the removed belt stopper for future transportation of the
printer.)
(7) Connect the power cord to the power connector located at the back of the printer.
(8) Connect the power cord to the outlet.
(9) Set the printhead.
Press the Power botton to power on the printer.
[1]
F-3-6
F-3-7
F-3-8
F-3-9
F-3-10
[1]
[1]
Chapter 3
3-3