Roll Feed Unit Pcb; Version Up; Firmware Update Tool - Canon imagePROGRAF iPF5000 Series Service Manual

Chapter 6

6.2.5 Roll feed unit PCB

J1 (Connect to main board)
Pin Number Signal name
1 GND
2 GND
3 ROLL_CLK
4 ROLL_DAT
5 ROLL_STB
6 /ROLL_SLEEP
7 VM
8 VM
9 ROLL_UNIT
10 ROLL_PAPER_SNS
11 ROLL_CAM_SNS
12 GND
13 OPT_5V
J2 (Roll media sensor )
Pin Number Signal name
1 +5V
2 GND
3 ROLL_PAPER_SNS
J3 (Roll cam sensor, roll motor)
Pin Number Signal name
1 +5V
2 GND
3 ROLL_CAM_SNS
4 GND
5 ROLL_OUTAP
6 ROLL_OUTAM
7 ROLL_OUTBP
8 ROLL_OUTBM

6.3 Version Up

6.3.1 Firmware Update Tool

Use of the following tools allows you to update the firmware of the system controller incorporated in the printer.
- GARO Firmware Update Tool
- L Printer Service Tool
1. GARO Firmware Update Tool
GARO Firmware Update Tool is the same as that for user.
Procedure
1) Start CARO Firmware Update Tool.
2) Place the printer in the online mode.
3) Transfer the firmware data to the printer according to the instructions shown on the display.
4) The data shown on the LCD on the operation panel changes and the firmware is updated automatically.
5) When firmware update is completed, the printer will start again.
6-22
J1
J2
F-6-5
T-6-43
IN/OUT Function
- GND
- GND
IN Roll motor driver clock signal
IN Roll motor driver data signal
IN Roll motor driver strobe signal
IN Roll motor driver sleep signal
IN Power supply (+26V)
IN Power supply (+26V)
OUT Roll unit detection signal
OUT Roll media sensor signal
OUT Roll cam sensor signal
- GND
IN Power supply (+5V)
T-6-44
IN/OUT Function
OUT Power supply (+5V)
- GND
IN Roll media sensor signal
T-6-45
IN/OUT Function
OUT Power supply (+5V)
- GND
IN Roll cam sensor signal
- GND
OUT Roll motor drive signal AP
OUT Roll motor power supply AM
OUT Roll motor drive signal BP
OUT Roll motor power supply BM
J3
0013-3771
0013-3917