Canon imageRUNNER 105 Network Manual page 60

3
3-20 Protocol Settings
M
Press [PING Command].
Sample screen for imageRUNNER 3300i
M
Enter an IP address that exists on the network, and then press [Start].
Use the keypad on the control panel to enter an IP address.
When you press [Start], the result of the PING command appears on the touch panel
display.
If this result is inappropriate, check the settings described in "Interface Settings," on p.
2-3 and "TCP/IP Settings," on p. 3-4.
IMPORTANT
•
If you set the startup time of the network function of the machine by following the
procedure in "Startup Time Settings," on p. 3-25, execute the PING command only
after the time you set as the startup time passes (the default setting startup time is
60 seconds).
•
If you connect the machine to a switching hub, the machine may not be able to
connect to a network even though your network settings are appropriate. This
problem may be resolved by delaying the startup time of the network function of the
machine. See "Startup Time Settings," on p. 3-25 for how to set up the startup time.