Protocol Settings; Settings From The Control Panel - Canon imageRUNNER 105 Network Manual

Protocol Settings

You can specify the protocol settings for the machine using any of the following:
•
Control panel
•
NetSpot (Utility software provided with the machine)
•
Web browser (Remote UI)
IMPORTANT
•
To configure settings with software other than the control panel of the machine or
NetSpot, TCP/IP protocol must be supported by your network environment. The following
procedures describe sample settings using the control panel.
NOTE
•
For instructions on entering settings using NetSpot, see Chapter 7 "Using the Network
and Device Settings with NetSpot."
•
For instructions on entering settings using a web browser (Remote UI), see "Chapter 2
6
Functions of the Remote UI" in the Remote UI Guide.

Settings from the Control Panel

IMPORTANT
•
AppleTalk is available only on Ethernet. You cannot use AppleTalk on Token Ring. When
the Token Ring board is installed on the machine, you cannot use AppleTalk. Remove the
Token Ring board if it is installed on the machine.
•
Settings from the control panel become effective when the machine is restarted after the
procedure.
•
For information on entering characters using the touch panel display, see "Chapter 1
Before You Start Using This Machine" in the Reference Guide.
1
6-4

Protocol Settings

Press (Additional Functions).