Printer Connection Method (Ipp); Windows 95/98/Me - Canon imageRUNNER 105 Network Manual

NOTE
•
The admintool utility belongs to the operating system. For specific operating
instructions, see the operating system manual.
•
The above procedures are only examples. The setup procedures for your
environment may differ.
•
You can specify a print queue. The following three print queues are available:
- LP
The machine prints according to its spool settings. Normally enter LP as a print
queue.
- SPOOL
The machine prints only after spooling a print job on the hard disk regardless of
its spool settings.
- DIRECT
The machine prints without spooling a print job on the hard disk regardless of its
spool settings.
•
When the job record appears on the touch panel display of this machine,
<unknown> may be displayed as Document Name and User Name of printing data
transmitted to DIRECT queue of this machine over UNIX network.
(To display the job record, press [System Monitor]
panel display in this order.)
The printer destination settings are completed.

Printer Connection Method (IPP)

Windows 95/98/Me

1
If you are using a machine other than the imageRUNNER
5000i, check the settings for [RX/Print Range] of [IP Address
Range Settings] to see whether the IP address of the
computer in which a printer driver is to be installed is
permitted. (See step 21 in "TCP/IP Settings," on p. 3-4.)
If you are using the imageRUNNER 5000i, this step is not required.
IMPORTANT
•
If the settings for [RX/Print Range] of [IP Address Range Settings] do not permit
the IP address, you cannot install a printer driver.
•
If the IP address of the computer is beyond the range of the permitted addresses
for [RX/Print Range] after installing a printer driver, you cannot print from the
computer.
Setting Up a Computer for Printing (Windows/UNIX)
→ →
[Print] [Log] on the touch
3
3-37