Canon imageRUNNER 105 Network Manual page 35

8
9
10
2
11
12
13
The Token Ring settings are completed.
2-10 Interface Settings
To perform all broadcast request, select [On] for [All
Broadcast Request].
If you select [On] for [All Broadcast Request], skip to step 10.
To perform all broadcast response notice, select [On] for [All
Broadcast Response Notice].
Specify the [LAA] settings.
M
If you want to use an LAA (Locally Administered Address), select [On], press
[LAA], and then enter the LAA.
The allowable range for an LAA is from 40 00 00 00 00 00 to 7F FF FF FF FF FF.
IMPORTANT
•
When you use an LAA, be sure to set a valid LAA. The machine will not work
normally if you use the default address without changing it.
•
Either the MAC address or LAA is required as the Token Ring node address. If you
do not set any LAA, the MAC address is used as the node address.
NOTE
•
The MAC address displayed on the touch panel display is unique to the Token Ring
board, and is set independently of the MAC address of the Ethernet board.
Confirm the settings you specified, and then press [OK].
The display returns to the Network Settings screen.
Press [Done].
Repeat this step until the Additional Function screen closes.
Restart the machine.
M
Turn OFF the machine, wait at least three seconds, and then turn it ON again.