Honeywell TH8320R1003 Installation Manual page 31

ISU Installer Setup
Number Name
313 Radiant Cycles
1 to 12 CPH
Per Hour Stage 1
Note: "Stage 1" is
not displayed if
there is only 1
stage of Radiant
Heat.
313 Radiant Cycles 1 to 12 CPH
Per Hour Stage 2
314 Cool / 1 to 6 CPH
Compressor
Cycles Per Hour
Stage 1
Note: "Stage 1" is
not displayed if
there is only 1
stage.
314 Cool / 1 to 6 CPH
Compressor
Cycles Per Hour
Stage 2
Table 2. Installer Setup (ISU) Table. (Continued)
Settings Default
3
3
3
3
31
VISIONPRO
Residential,
Commercial Requires
or Both EIM
Both No This ISU is only displayed when ISU 201
Heating Equipment is Geothermal Radiant.
The thermostat automatically defaults to the
recommended setting for Geothermal Radiant
Heat (3 CPH).
Cycle rate limits the maximum number of
times the system can cycle in a 1 hour period
measured at a 50% load. For example, when
set to 3 CPH, at a 50% load, the most the
system will cycle is 3 times per hour (10
minutes on, 10 minutes off). The system
cycles less often when load conditions are
less than or greater than a 50% load.
Both Yes This ISU is only displayed when ISU 201
Heating Equipment is Geothermal Radiant.
The thermostat automatically defaults to the
recommended setting for Geothermal Radiant
Heat (3 CPH).
Cycle rate limits the maximum number of
times the system can cycle in a 1 hour period
measured at a 50% load. For example, when
set to 3 CPH, at a 50% load, the most the
system will cycle is 3 times per hour (10
minutes on, 10 minutes off). The system
cycles less often when load conditions are
less than or greater than a 50% load.
Both No This ISU is only displayed when ISU 207 Cool
/ Compressor Stages is set to 1 stage.
Cycle rate limits the maximum number of
times the system can cycle in a 1 hour period
measured at a 50% load. For example, when
set to 3 CPH, at a 50% load, the most the
system will cycle is 3 times per hour (10
minutes on, 10 minutes off). The system
cycles less often when load conditions are
less than or greater than a 50% load.
Both No This ISU is only displayed when ISU 207 Cool
/ Compressor Stages is set to 2 stages.
Cycle rate limits the maximum number of
times the system can cycle in a 1 hour period
measured at a 50% load. For example, when
set to 3 CPH, at a 50% load, the most the
system will cycle is 3 times per hour (10
minutes on, 10 minutes off). The system
cycles less often when load conditions are
less than or greater than a 50% load.
®
8000 WITH REDLINK™
Notes
68-0312—03