Remote Indoor Sensors - Honeywell TH8320R1003 Installation Manual

®
VISIONPRO 8000 WITH REDLINK™

REMOTE INDOOR SENSORS

For installation, see "C7189R1004 Wireless Indoor Sensor" on
page 59, and "C7189U1005 Wired Indoor Sensor" on page 59.
For wiring, see "Wiring guide — Wired Indoor Sensors" on
page 135.
Indoor Sensor Operation
Temperature Control
The thermostat can be set to respond to its internal
temperature sensor, or to an optional remote indoor sensor. If
multiple sensors are used, the thermostat will average the
temperature detected at each sensor.
In Fig. 305, both the thermostat internal sensor and remote
indoor sensor are being used for Temperature Control and are
being averaged since both sensors are set to "Yes." Select "No"
if you do NOT want a specific sensor to be used for
temperature control or be part of the temperature average.
When using multiple remote indoor sensors, you should name
each sensor after you link it to the thermostat. See "Wireless
Indoor Sensor" beginning on page 18 for more information.
Naming the sensors allows you to select the appropriate
sensor(s) for Temperature Control in the Installer Setup.
Humidification control
If optional remote indoor sensors are installed, you can choose
which sensor you want to use for humidification control. You
can use a different sensor for dehumidification.
When using multiple remote indoor sensors, you should name
each sensor after you link them to the thermostat. See
"Wireless Indoor Sensor" beginning on page 18 for more
information. Naming the sensors allows you to select the
68-0312—03
Fig. 305.
appropriate sensor for Humidification Control in the Installer
Setup. For example, in Fig. 306, the MAIN LEVEL remote
indoor sensor is selected for Humidification Control.
NOTE: Requires wireless indoor sensor. Humidity sens-
ing can not be averaged.
Dehumidification control
If optional remote indoor sensors are installed, you can choose
which sensor you want to use for dehumidification control. For
example, you can use one sensor for humidification control,
and another for dehumidification.
When using multiple remote indoor sensors, you should name
each sensor after you link them to the thermostat. See
"Wireless Indoor Sensor" beginning on page 18 for more
information. Naming the sensors allows you to select the
appropriate sensor for Dehumidification Control in the Installer
Setup. For example, in Fig. 307, the CRAWL SPACE remote
indoor sensor is selected for Dehumidification Control.
NOTE: Requires wireless indoor sensor. Humidity sens-
ing can not be averaged.
112
Fig. 306.
Fig. 307.