Honeywell TH8320R1003 Installation Manual page 18

®
VISIONPRO 8000 WITH REDLINK™
Wireless Indoor Sensor
1. Press and quickly release the CONNECT button. After a
short delay, the status light (see Fig. 51) will glow green
for 15 seconds. If the status light turns red, the sensor
did not link with the thermostat.
MCR32934
Fig. 51. Wireless indoor sensor connect button and status
NOTE: In normal operation, the status light remains off.
If it begins flashing red, batteries are low (power
will be depleted after 2–3 weeks).
2. After a short delay (up to 15 seconds), check thermostat
to confirm the connection of the sensor.
3. If you are installing more than 1 wireless indoor sensor,
give each sensor a name as you install it. Press Yes
when the "Rename Indoor Sensor?" screen is displayed,
as shown in Fig. 53.
4. Select the Indoor Sensor name from the list and press
Done. The Indoor Sensor names are used when select-
ing which sensor to use for temperature control, humidifi-
cation control, and dehumidification control.
68-0312—03
MCR32935
light.
Fig. 52.
Fig. 53.
NOTE: If you link more than 1 wireless indoor sensor,
and forget to name them, you will be prompted
to name each wireless indoor sensor after you
exit wireless setup. See Fig. 55.
Entry/Exit Remote or Vent Boost Remote
1. Press and quickly release the CONNECT button.
Fig. 56. Connect button and status light on Entry/Exit
Remote or Vent Boost Remote.
2. After a short delay, the status light will glow green for 15
seconds. If the status light turns red, the remote did not
link with the thermostat for the connection process.
NOTE: The thermostat can work with up to 3 Entry/Exit
remotes. Each Entry/Exit remote can control up to
16 thermostats.
NOTE: The thermostat can work with up to 6 Vent Boost
remotes.
18
Fig. 54.
Fig. 55.
MCR33096