Feed Key; Move To Tearoff - Toshiba BA400 Series Key Operation Specification

・ ECO+Backfeed
Notes: 1. This function is enabled only when the sensor type is set to other than "None".
2. Conditions for enabling ECO + Backfeed
Operation
3. In the case the printer cannot detect a gap/black mark while feeding the media, an error occurs on the
following condition. Regarding an error during a feed, refer to the External Equipment Interface
Specification for the BA400 series
OFF
STD
ECO
ECO + Backfeed

8.5.2 FEED KEY

・ FEED
Feed one label.
・ PRINT
Print data in the image buffer on one label.

8.5.3 MOVE TO TEAROFF

・ OFF
Disables the auto feed to the cut/strip position after printing.
・ ON
Enables the auto feed to the cut/strip position after printing.
8.5.3.1 MOVE TO TEAROFF POS.
When the "MOVE TO TEAROFF" parameter is set to ON, the feed amount can be fine adjusted.
Max.
Min. value
value
+5.0 -5.0
Note: Feed amount setting
・ + (Plus)
Increases the forward feed amount.
・ - (Minus) Decreases the forward feed amount.
calculated based on the stored media pitch.
After performing above-mentioned ECO, the printer feeds the media backward for the
label pitch length while raising the print head if the following conditions are satisfied.
Media pitch falls between 20mm and 100mm.
The previous issue mode was Batch. (The issue mode is not reset by a power off or a
printer reset.)
When the relation between the stored media pitch (A) and the media pitch
detected by the sensor (B) does not satisfy the following formula, it will be an
error:
(A) × 50%  (B)  (A) × 150%
When a gap/black mark is not detected while feeding 1500-mm media, it will be
an error.
Step Display
0.1 Decimal
Integer Decimal
Sign
digit
Exist 1
73
Unit of
0-padding
place measure
1 None mm