Christie D12HD-H User Manual page 50

Section 4: OPERATION
NOTE:

PIP/PBP layout and size table as described below.

P : indicates primary source region (lighter color).

* : Both source regions are the same size.
PBP, Bigger Left
Over-Under, Bigger Upper
PBP, Bigger Right
Over-Under, Bigger Lower
PIP-Bottom Right
PIP-Bottom Left
PIP-Top Left
PIP-Top Right
Timing Detection Mode
Select timing detection mode to wide or normal. It is used to support additional
PC timings. When the projected picture is not completed, this function is used
to adjust the picture. "Normal mode" can support all of the 4:3 input sources.
"Wide mode" can support all of the 16:9 input source & most of the 4:3 input
source. For those 4:3 input sources not recognized by "Wide mode" (for
example 1400 x 1050), perform Auto Image using "normal mode".
Source Info
Display current source settings (read-only).
Input key
Use it to list all of the sources or change the sources.
Blank on Signal Switch
When the function is enabled, the projector blanks the screen before timing is
stable when changing source.
4-19
PIP/PBP Layout
PIP/PBP Size
Small Medium
P P
P
P
P P
P
P
P P
P P
P P
P P
Large
P
P
P
P
P
P
P
P
H Series User Manual
020-000772-02 Rev.1 (08-2015)