Input Switching & Pip Menu - Christie M Series User Manual

Section 3: Operation
3.10 Input Switching & PIP Menu
Use the Input Switching & PIP menu to
enable and define how you want to use PIP.
To control the primary image, access
NOTE:
all picture controls through the Main menu.
To control the secondary (PIP) image, access
picture controls through the Input Switching
& Picture-in-Picture menu.
MAIN INPUT
From the list of active inputs, select one to be
used as the primary or main image.
PIP INPUT
From the list of active inputs, select one to be used as the secondary or PIP.
SWAP MAIN & PIP INPUTS
Toggle the current PIP relationship so that the primary (main) image becomes secondary (PIP), and the
secondary image becomes primary. Swapping is available only when PIP is enabled.
experience a slight delay when swapping the Primary and Secondary images.
PIP ENABLE
Short cut: Press PIP on the Remote if menu not
present.
Toggle between displaying two sources at once
(Main and PIP images) and the primary or main
source only. This check box turns the secondary
source on and off.
3-54
F 3-40 I S
IGURE NPUT WITCHING
& PIP
You may
NOTE:
M Series User Manual
020-100009-05 Rev. 1 (09-2010)