Special Tools - Toro Greensmaster 3250-D 04383 Service Manual

Special Tools

Order special tools from your Toro Distributor.
Gauge Bar Assembly
Used to verify height--of--cut.
Toro Model Number: 13- -8199
Backlapping Brush Assembly
Used to apply lapping compound to cutting units while
keeping the operator's hands at a safe distance from the
rotating reel.
Toro Model Number: TOR299100
Bedknife Screw Tool
This screwdriver--type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
IMPORTANT: DO NOT use and air or manual impact
wrench with this tool so damage to the bedbar will
be prevented.
Toro Model Number: TOR510880
Roller Bearing Installation Tools
Washers and spacer used to install bearings and seals
into front and rear rollers that have a threaded roller
shaft.
Seal installation washer (black): # 107--8133
Seal installation spacer: # 107--3505
Bearing installation washer (yellow): # 104--6126
Greensmaster 3250--D
Some tools may have been supplied with your mower or
available as TORO parts. Some tools may also be avail-
able from a local supplier.
Seal Installation
Washer
Page 7.1 - - 3 Rev. I
Dual Point Adjust Cutting Units (Rev. D)
Figure 2
Figure 3
Figure 4
Bearing Installation
Seal Installation
Washer
Spacer
Figure 5