Rear Wheel (3Wd) - Toro Greensmaster 3250-D 04383 Service Manual

Rear Wheel (3WD)

80 to 100 in−lb
(9.0 to 11.3 N−m)
6
RIGHT
FRONT
30 ft−lb
(41 N−m)
1. Castor fork
2. Hub and motor assembly
3. Hydraulic hose
4. Hydraulic hose
5. Bearing
6. Relube flangette
7. Grease fitting
8. Standard flangette
9. Bearing tab
Removal (Fig. 5)
1. Park machine on a level surface. Make sure engine
is off. Set brake and block front wheels.
2. Jack up and secure the rear wheel off the ground.
CAUTION
Support wheel (25) and motor and hub assembly
(2) to prevent dropping them and causing per-
sonal injury while removing hex head screws
(10) and socket head screws (12).
3. Remove wheel (25) and hydraulic motor and hub
assembly (2) from the castor fork (1) as follows:
A. Remove hex head screws (10) and lock nuts (11)
securing flangettes (6 and 8) and bearing tab (9).
Greensmaster 3250−D
18
16
3
20
4
19
9
11
23
21
24
7
5
8
10
25
Figure 5
10. Cap screw
11. Lock nut
12. Hex socket head screw
13. Lock nut
14. Cable tie
15. Tube clamp
16. Cover plate
17. Cap screw
Page 6 − 7
15
17
1
22
3
13
4
2
18. Lock nut
19. Clamp bracket
20. Hex washer head screw
21. Bearing adapter plate
22. Grease fitting
23. Lug nut
24. Set screw
25. Wheel/tire assembly
B. Remove both socket head screws (12) and lock
nuts (13) securing the hydraulic motor and hub as-
sembly to the castor fork (1).
C. Lower wheel and hydraulic motor and hub as-
sembly from the castor fork.
4. Loosen set screws (24) on bearing (5). Pull flan-
gettes (6 and 8) and bearing from the hydraulic motor
shaft.
5. Remove grease fitting (22) from the hydraulic motor
and hub assembly (2). Remove four lug nuts (23) and
wheel (25) from the hub drive studs.
6. If the castor fork (1) requires removal, see Rear
Wheel (2WD) Removal.
14
85 ft−lb
12
(115 N−m)
Chassis (Rev D)