Reel Motors - Toro Greensmaster 3250-D 04383 Service Manual

Reel Motors

15
17
8
15
RIGHT
FRONT
1. Cap screw
2. Flat washer
3. Tube clamp
4. Lock nut
5. Plug
o
6. 90 Hydraulic fitting
7. Hydraulic fitting
8. Hydraulic fitting
9. Not used
10. Bulkhead nut
11. Washer
Removal (Fig. 44 and 45)
1. Before removing any parts from the hydraulic sys-
tem, park machine on a level surface, engage parking
brake, lower cutting units, and stop engine.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components.
Hydraulic System (Rev. I)
29
14
7
19
30
7
29
30
6
10
13
14
27
12. Spacer
13. Reel motor
14. Hose assembly
15. Hose assembly
16. Hydraulic fitting
17. Hose assembly
18. T- -block
19. Cap screw
20. Hydraulic tube
21. Hydraulic tube
1
3
20
5
31
18
16
11
24
26
17
12
11
7
27
6
28
13
28
8
Figure 44
2. Remove reel motor from the cutting unit (see Cut-
ting Unit Removal and Installation in Chapter 7-- Cutting
Units).
Note: The position of hydraulic fittings on the reel mo-
tor is critical to properly reconnecting hydraulic hoses.
3. Label all hose connections for reassembly pur-
poses. Matchmark reel motor and all hydraulic fittings
for reassembly purposes.
Page 4 - - 74
2
3
4
23
22
21
25
FRONT REEL MOTORS
22. Hydraulic tube
23. Hydraulic tube
24. Rubber grommet
25. O- -ring
26. O- -ring
27. O- -ring
28. O- -ring
29. O- -ring
30. O- -ring
31. O- -ring
Greensmaster 3250--D