Toro Greensmaster 3250-D 04383 Service Manual page 140

Installation (Fig. 65)
1. Install removed hose assemblies and O--rings to the
steering control valve. Install removed hydraulic fittings
and O--rings to the control valve.
2. Install steering column assembly to the steering
control valve.
3. While routing hydraulic hoses to machine, position
steering control valve into the steering cover assembly.
Secure control valve to steering arm cover with cap
screws.
4. For hydraulic hose(s) that thread directly into control
valve, correctly connect opposite end of hose to fitting
on hydraulic manifold or steering cylinder.
Hydraulic System (Rev. I)
5. Connect remaining hoses to fittings in steering con-
trol valve.
6. Install cable tie to the hose assemblies.
7. Position steering valve cover (16) to the steering
cover assembly (14). Secure cover to assembly with
screws (13) and speed nuts (25).
8. Apply antiseize lubricant to splines of steering col-
umn. Install steering wheel and secure with nut. Torque
nut to 35 ft- -lb (47 N- -m).
9. Secure steering wheel cap to the steering wheel
with screw.
Page 4 - - 102 Greensmaster 3250--D