Toro Greensmaster 3250-D 04383 Service Manual page 197

Disassembly (Fig. 10)
1. Park machine on a level surface. Make sure engine
is off and brake is set.
2. Remove cutting unit from front lift arm (see Opera-
tor's Manual).
3. Disassemble front lift arm as needed using Figures
10 and 11 as guides.
Assembly (Fig. 10)
1. Assemble front lift arm using Figures 10 and 11 as
guides.
A. If clevis (item 29) was removed from front lift
frame, torque cap screw from 67 to 83 ft−lb (91 to
112 N−m).
B. If pull frame (item 1 in Fig. 11) was removed from
clevis on lift frame, torque cap screw from 67 to 83
ft−lb (91 to 112 N−m).
2. Attach cutting unit to lift arm (see Operator's Manu-
al).
3. Check that when raised to the transport position, the
cutting units are secured by the transport plate. If neces-
sary, loosen two cap screws (item 28) and reposition
transport plate.
Greensmaster 3250−D
1
2
3
3
1. Pull frame
2. Pivot spacer
3. Bushing
Page 6 − 13
5
67 to 83 ft−lb
(91 to 112 N−m)
4
6
Figure 11
4. Clevis
5. Cap screw
6. Lock nut
Chassis (Rev D)