General Information; Lift Roller Position - Toro Greensmaster 3250-D 04383 Service Manual

General Information

Lift Roller Position

The cutting unit comes with its lift roller installed in the
top position. The position of the roller may be changed
as follows:
1. Remove hex head screw and lock nut from the lift
roller and frame.
2. Position lift roller to the proper hole on the frame. In-
sert hex head screw through the frame and roller.
Lower Hole − for increased transport height.
Upper Hole − standard transport height so the cut-
ting unit is level when it touches down upon lower-
ing.
3. Secure hex head screw with the lock nut.
SPA and 4−Bolt Cutting Units (Rev. A)
1. Lift roller
Page 7 − 4
1
2
Figure 15
2. Hex head screw
Greensmaster 3250−D