Toro Greensmaster 3250-D 04383 Service Manual page 25

Muffler Removal (Fig. 13)
1. Park machine on a level surface, lower the cutting
units, stop the engine, engage parking brake, and re-
move the key from the ignition switch.
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the muf-
fler.
2. Remove muffler shield (8) from from the muffler (7)
by removing the four cap screws (4) securing the shield
to the muffler.
3. Remove clamp (10) securing the exhaust pipe (12)
to the muffler (7).
4. Remove two cap screws (4) securing the muffler (7)
to the rear of the pump plate (30). Carefully separate
muffler from the pump plate and exhaust pipe (12).
5. Further disassemble muffler as necessary.
Muffler Installation (Fig. 14)
1. Make sure the engine is off.
Note: Mount all fasteners before securing tightly to
ensure a proper fit.
2. If the exhaust plate (11) was removed, install plate
to exhaust manifold with a new gasket. Secure plate to
the manifold with metric hex nuts (28).
3. If the exhaust pipe (12) was removed, install pipe to
exhaust plate (11) with clamp (10).
4. Carefully attach muffler (7) to the exhaust pipe (12).
Secure muffler (7) to the pump plate (30) with two cap
screws (4).
5. Secure exhaust pipe (12) to the muffler (7) with
clamp (10).
6. Secure muffler shield (8) to the muffler (7) with four
cap screws (4).
Greensmaster 3250−D
Air Cleaner Removal (Fig. 15)
1. Park machine on a level surface, lower the cutting
units, stop the engine, engage parking brake, and re-
move the key from the ignition switch.
2. Loosen hose clamp (19), and disconnect air cleaner
hose (17) from the air cleaner body (6).
3. Remove lock nut (18) from cap screw (16).
4. Remove air cleaner body (6) from the mounting
bracket (5).
5. Further disassemble air cleaner as necessary.
Air Cleaner Installation (Fig. 16)
1. Make sure the engine is off.
2. If the air cleaner bracket (2) was removed, secure
bracket to the frame with two cap screws (26), flat wash-
ers (15), flat washers (15), and lock nuts (3).
3. If the mounting bracket (5) was removed, secure
bracket to the air cleaner bracket (2) with two cap screws
(16) and lock nuts (18).
4. Carefully place air cleaner body (6) into the mount-
ing bracket (5).
5. Reconnect air cleaner hose (17) to the air cleaner
(6) and secure with hose clamp (19).
Page 3 − 11 Engine