Special Tools - Toro Greensmaster 3250-D 04383 Service Manual

Special Tools

Order these special tools from your Toro Distributor.
Hydraulic Pressure Test Kit - - TOR47009
Use to take various pressure readings for diagnostic
tests. Quick disconnect fittings provided attach directly
to mating fittings on machine test ports without tools. A
high pressure hose is provided for remote readings.
Contains one each: 1000 PSI (70 Bar), 5000 PSI (350
Bar) and 10000 PSI (700 Bar) gauges. Use gauges as
recommended in Testing section of this chapter.
Hydraulic Tester (Pressure and Flow) - - TOR214678
This tester requires O--ring face seal (ORFS) adapter fit-
tings for use on this machine. Use hydraulic tester as
recommended in Testing section of this chapter.
1. INLET HOSE: Hose connected from the system cir-
cuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: A simulated working load is created
in the circuit by turning the valve to restrict flow.
3. PRESSURE GAUGE: 0 to 5000 PSI gauge to pro-
vide operating circuit pressure.
4. FLOW METER: This meter measures actual oil flow
in the operating circuit with a gauge rated at 15 GPM.
5. OUTLET HOSE: A hose from the outlet side of the
hydraulic tester connects to the hydraulic system circuit.
O- -ring Kit - - 16- -3799
The kit includes O--rings in a variety of sizes for face seal
and port seal hydraulic connections. It is recommended
that O--rings be replaced whenever a hydraulic connec-
tion is loosened.
Hydraulic System (Rev. I)
Page 4 - - 26
Figure 10
Figure 11
Figure 12
Greensmaster 3250--D