Hydraulic Reservoir - Toro Greensmaster 3250-D 04383 Service Manual

Hydraulic Reservoir

30 to 60 in- -lb
(3.4 to 6.8 N- -m)
22
26
27
7
1. Hydraulic barb fitting
2. Hydraulic straight fitting
3. Fuel tank clamp
4. Hex washer head screw
5. Tank cap
6. Hydraulic tank
7. Hydraulic straight fitting
8. Oil filter assembly
9. Hydraulic barb fitting
10. Oil filter mount
Removing Hydraulic Reservoir (Fig. 84)
1. Before removing any parts from the hydraulic sys-
tem, park machine on a level surface, set brake, lower
cutting units, and stop engine.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components.
Hydraulic System (Rev. I)
25
2
14
29
16
4
13
12
16
10
8
9
11. O- -ring
12. Flat washer
13. Grommet
14. O- -ring
15. Flat washer
16. Cap screw
17. Filter screen
18. Cap screw
19. Plug
20. Air breather
5
20
24
11
1
28
19
21
23
Figure 84
2. Place a suitable container under the hydrostat to
collect hydraulic oil. Clamp pump inlet hose to prevent
drainage. Remove pump inlet hose from hydrostat and
direct to container. Release clamp from hose (Fig. 85).
3. Disconnect hose assembly from the hydraulic fitting
welded to the reel motor case drain tube located below
the right side of the frame. Allow hose to drain to a suit-
able container (Fig. 86).
4. Disconnect return hose (21) from hydraulic barb fit-
ting (9). Allow hose to drain to a suitable container.
Page 4 - - 116
18
15
18
17
15
3
6
9
23
21. Return hose
22. Tube assembly
23. Hose clamp
24. Serrated plug
25. O- -ring
26. O- -ring
27. O- -ring
28. O- -ring
29. Mounting plate
Greensmaster 3250--D
v