Toro Greensmaster 3250-D 04383 Service Manual page 113

4
18
8
17
12
5
4
19
13
1
28
13
RIGHT
FRONT
1. Bulkhead lock nut
2. Bulkhead lock nut
3. Hex washer head screw
4. Hydraulic hose
5. Reel motor
6. Bulkhead bracket
7. Hydraulic tube
8. Hydraulic hose
9. Washer
10. Spacer
4. Remove hose connections from the hydraulic fit-
tings on the reel motor. Allow hydraulic oil to drain from
hoses into a suitable container. Put caps or plugs on
ends of hoses to prevent contamination.
5. Remove hydraulic fittings and O--rings from the reel
motor. Put caps or plugs in motor openings to prevent
contamination.
Installation (Fig. 44 and 45)
1. Inspect threads and sealing surfaces of fittings. Re-
place any worn or damaged fittings.
2. Apply clean hydraulic oil to all O--rings.
Greensmaster 3250--D
2
9
10
11
Figure 45
11. Grommet
12. Hydraulic straight fitting
o
13. 90 Hydraulic fitting
14. Hose bracket
15. Clamp
16. Hydraulic hose
17. O- -ring
18. O- -ring
19. O- -ring
Page 4 - - 75
1
9
27
21
6
3
15
20
3
22
26
16
7
9
20. Tube clamp
21. Cap screw
22. Lock nut
23. Hydraulic T- -fitting
24. Hose retainer
25. Lock nut
26. Hose retainer
27. Cable tie
28. O- -ring
3. Place O--ring on the face seal of a hydraulic fitting.
Secure fitting to the reel motor. Make sure that the match
marks are aligned. Repeat this step for the remaining fit-
tings.
4. Inspect threads and sealing surfaces of connec-
tions. Replace any worn or damaged connections.
5. Install reel motor to the cutting unit (see Cutting Unit
Removal and Installation in Chapter 7-- Cutting Units).
6. Secure hose connection to the proper hydraulic fit-
ting on the reel motor. Repeat this step for the remaining
hose connections.
10
11
3
25
14
9
23
24
3
REAR REEL MOTOR
Hydraulic System (Rev. I)