Toro Greensmaster 3250-D 04383 Service Manual page 190

D. Place second bearing cone on the castor fork
shaft with the wide edge up. Place remaining steer-
ing washer on top of the bearing cone.
E. Run slotted hex nut (1) onto castor fork shaft until
drag is felt while rotating the castor fork. Back−off
hex nut to align the hole to the slot. Install and se-
cure cotter pin (2) into the shaft.
F. Secure ball joint (17) to the castor fork (4) with
both jam nuts (26). Torque 65 to 85 ft−lbs (88 to 115
N−m).
G. Secure fuel tank base plate to the frame with
three hex head screws and flat washers. The two
screws and flat washers go on the top of the plate at
the front corners of the tank. The third screw goes
through support from under the plate.
Chassis (Rev. D)
3. Install wheel and hub assemblies into the castor fork
(4). Insert bolt (5) into motor adapter plate (34) mounting
hole. Install a spacer (29), and slide bolt through the
wheel and hub assemblies.
4. Install another spacer (29) onto the bolt (5). Route
the bolt through the adapter plate (35) mounting hole.
5. Position bent lip of the bolt (5) head under the bot-
tom edge of the motor adapter plate (34). Install and
tighten locknut (16) to secure wheel to the castor fork.
Do not overtighten locknut, the wheel must rotate freely.
6. Wipe grease fitting (10) clean on hub (9) and pivot
housing. Pump grease into hub until grease is seen exit-
ing at both oil seals (6). Pump grease into pivot housing
until grease is seen exiting at both ends of the housing.
Wipe up excess grease.
Page 6 − 6 Greensmaster 3250−D