Toro Greensmaster 3250-D 04383 Service Manual page 121

7. Plug ends of the oil cooler. Clean exterior of the
cooler.
8. The oil cooler should be free of corrosion and exces-
sive pitting of tubes.
Installation (Fig. 52)
1. Make sure formed hoses and openings of the oil
cooler are clean.
2. Hang oil cooler onto cooler brackets while attaching
the formed hoses to the cooler. Secure hoses by tighten-
ing the hose clamps.
Greensmaster 3250--D
3. Clean radiator screen and reinstall.
4. Remove clamps that where used to prevent drain-
age from the formed hoses.
5. Fill hydraulic tank (see Check Hydraulic System
Fluid).
6. Start machine. Run machine at idle for 3 to 5 min-
utes to circulate hydraulic fluid and remove any air
trapped in the system. Stop machine and recheck hy-
draulic tank level.
Page 4 - - 83
Hydraulic System (Rev. I)