Toro Greensmaster 3250-D 04383 Service Manual page 199

Disassembly (Fig. 12)
1. Park machine on a level surface. Make sure engine
is off and brake is set.
2. Remove center cutting unit from lift arm (see Opera-
tor's Manual).
3. Disassemble center lift arm as needed using Fig-
ures 12 and 13 as guides.
Assembly (Fig. 10)
1. If lift frame (item 25) was removed from machine:
A. Adjust eccentric bushings (item 22) as needed
so that lift frame is level when the lift frame is in the
raised position.
B. Install thrust washers (item 12) as needed so
that lift frame is centered between the front wheel
mounts when the lift frame is in the raised position.
2. Assemble center lift arm using Figures 12 and 13 as
guides.
A. If clevis (item 31) was removed from center lift
frame, torque cap screw from 67 to 83 ft−lb (91 to
112 N−m).
B. If pull frame (item 1 in Fig. 13) was removed from
clevis on lift frame, torque cap screw from 67 to 83
ft−lb (91 to 112 N−m).
3. Attach cutting unit to lift arm (see Operator's Manu-
al).
4. Check that when raised to the transport position, the
cutting unit is secured by the transport plate. If neces-
sary, loosen two cap screws (item 30) and reposition
transport plate.
Greensmaster 3250−D
1
2
3
3
1. Pull frame
2. Pivot spacer
3. Bushing
Page 6 − 15
5
67 to 83 ft−lb
(91 to 112 N−m)
4
6
Figure 13
4. Clevis
5. Cap screw
6. Lock nut
Chassis (Rev D)