General Information - Toro Greensmaster 3250-D 04383 Service Manual

General Information

Groomer Position
IMPORTANT: Before changing groomer position,
make certain that the reel drive is in the disengaged
position and that the cutting reel is not rotating.
To place the groomer reel in the raised, non−grooming
position, remove the lock screw and rotate the lift arm to
raise the groomer reel. Install the lock screw to retain the
groomer reel in the non−grooming position (Fig. 1).
To place the groomer reel in the lowered, grooming posi-
tion, remove the lock screw and rotate the lift arm to low-
er the groomer reel. Install the lock screw to retain the
groomer reel in the grooming position (Fig. 2).
Greensmaster 3250−D
1. Lift arm
1. Lift arm
Page 7.2 − 3 Groomer (DPA Cutting Unit) (Rev. D)
1
Figure 1
2. Lock screw (transport)
2
1
Figure 2
2. Lock screw (grooming)
2