Toro Greensmaster 3250-D 04383 Service Manual page 32

10. Remove fuel tank and hydraulic reservoir as fol-
lows:
A. Remove three cap screws (6) and two flat wash-
ers (14) securing tank mounting plate (13) to the
support bracket (17) and frame (Fig. 18).
B. Disconnect hydraulic hose to power steering
from from the hydraulic reservoir. Make sure hose to
gear pump is disconnected at the pump (Fig. 22).
C. If the oil cooler is not installed, disconnect hy-
draulic hose from the hydraulic oil filter (Fig. 23).
D. Disconnect fuel hose (21) going to the fuel filter/
water separator at the fuel shut−off fitting (9) (Fig.
18). Disconnect double hose clamp (12) from fuel
hose (48) and rear engine mount (11) near the over
flow tank (Fig. 19).
E. Disconnect fuel hose from the injector pump that
goes to the fuel tank (Fig. 24). Loosen clamps (19
and 20) to allow removal of the hose (Fig. 18).
F. Disconnect fuel hose coming from the fuel filter/
water separator at the injector pump inlet (Fig. 24).
G. Make sure cable ties and hose clamps securing
hoses to the frame and supports are removed.
H. Lift mounting plate and tanks from the machine.
11. Loosen socket head screw securing the throttle
cable to cable clamp. Disconnect cable from the cable
clamp and speed control lever (Fig. 25).
4
3
Figure 22
1. Hose (to gear pump)
2. Hose clamp
3. Hose (to power steering)
Engine
5
2
1
4. O−ring
5. Hydraulic reservoir
Page 3 − 18
2
Figure 23
1. Hydraulic hose
3
Figure 24
1. Hose (to fuel tank)
2. Injector pump
3. Hose (from fuel filter/wa-
ter separator
1
2
3
Figure 25
1. Socket head screw
2. Cable clamp
1
2. Hydraulic oil filter
2
1
4
3. Throttle clamp
4. Speed control lever
Greensmaster 3250−D