Toro Greensmaster 3250-D 04383 Service Manual page 89

Procedure for Steering Control Valve Test
1. Make sure the hydraulic tank is full.
2. Make sure hydraulic oil is at normal operating tem-
perature by operating the machine for approximately ten
(10) minutes.
3. Drive machine slowly in a figure eight on a flat level
surface.
A. There should be no shaking or vibration in the
steering wheel or rear wheel.
B. Steering wheel movements should be followed
immediately by a corresponding rear wheel move-
ment without the steering wheel continuing to turn.
4. Stop the unit with the engine running. Turn steering
wheel with small quick movements in both directions.
Let go of the steering wheel after each movement.
A. The steering wheel must go back immediately to
the neutral position.
B. The steering wheel should not continue to turn.
Note: The steering wheel must be able to turn with no
more than 45 in- -lb (5.1 N- -m) of torque.
Note: This steering test procedure will be affected by
incorrect rear tire pressure, binding in the hydraulic
steering cylinder, extra weight on the vehicle, and/or
binding of the steering fork assembly. Make sure that
these items are checked before proceeding with any hy-
draulic testing procedure.
5. Perform the Implement Relief Valve (R5) Pressure
and Gear Pump (P2) Flow tests to make sure that relief
valve and gear pump are functioning correctly.
6. If either of these performance tests indicate a steer-
ing problem, determine if the steering cylinder is faulty
using the following procedure.
A. Park machine on a level surface with the cutting
units lowered and off. Make sure engine is off and the
parking brake is engaged.
B. Turn the steering wheel all the way to the left
(counterclockwise) so the steering cylinder rod is ful-
ly extended.
C. Turn engine off.
Greensmaster 3250--D
REMOVE
THIS HOSE
Before continuing further, read and become fa-
miliar with Precautions for Hydraulic Testing.
D. Read Precautions for Hydraulic Testing.
E. Remove hydraulic hose from the 90
rod end of the steering cylinder. Plug the end of the
hose.
F. With the engine off, continue turning the steering
wheel to the left (counterclockwise) with the steering
cylinder fully extended. Observe the open fitting on
the steering cylinder as the steering wheel is turned.
If oil comes out of the fitting while turning the steering
wheel to the left, the steering cylinder has internal
leakage and must be repaired or replaced.
G. Remove plug from the hydraulic hose. Recon-
nect hose to the steering cylinder fitting.
7. If steering problem exists and steering cylinder
tested acceptably, steering control valve requires ser-
vice (see Steering Control Valve and Steering Control
Valve Service).
Page 4 - - 51
Figure 21
CAUTION
o
fitting on the
Hydraulic System (Rev. I)