Service And Repairs; Rear Wheel (3Wd) - Toro Reelmaster 2300-D Service Manual

Service and Repairs

Rear Wheel (3WD)

Removal
1. Park machine on a level surface. Ensure engine is
off. Set hand brake and block front wheels.
2. Lift rear wheel off the ground using a jack. Secure
back of the frame.
3. Remove lug nuts from the wheel hub studs. Slide off
wheel assembly.
4. Remove lock nut from the wheel motor shaft.
IMPORTANT: DO NOT hit wheel hub with a hammer
during removal or installation. Hammering may
cause damage to the wheel motor.
5. Mount a wheel puller to the wheel hub studs and re-
move the wheel hub off the wheel motor shaft. Remove
the woodruff key.
6. Remove rust from all parts with a wire brush prior to
installation. Clean all parts. Replace any worn or dam-
aged parts.
Installation
1. Install woodruff key and wheel hub onto the wheel
motor shaft.
2. Install lock nut to wheel motor shaft and tighten to
a torque of 250 to 400 ft–lb (34.6 to 55.3 kg–m).
3. Install wheel assembly and secure the lug nuts to
the wheel hub studs.
4. Tighten lug nuts evenly in a crossing pattern to a
torque of 45 to 65 ft–lb (6.22 to 8.98 kg–m).
Wheels and Brakes
8
5
6
1. Lug nut
2. Wheel hub stud
3. Wheel assembly
4. Lock nut
Page 6 – 4
7
2
4
Figure 2
5. Wheel motor shaft
6. Wheel hub
7. Woodruff key
8. Wheel motor
Reelmaster 2300–D/2600–D
3
1