Error Code; Reception - Konica Minolta magicolor 2490MF Service Manual

Field Service Ver. 1.0 Jul. 2006

18.4 Error code

18.4.1

Reception

Code
0001 No G3 signal received within 35 sec. in manual receive mode.
0003 Received DIS after sending DIS signal.
0004 Received DCN after sending DTC signal.
0006 Detect busy tone within receiving phase B.
0009 Can not receive any signal within 35 sec. in manual polling mode.
0010 Received DCN signal after sending DTC signal in polling RX.
0011 Can not receive any correct response after sending three DTC signals.
0012 Remote side Password does not match in polling RX/our side no file to be polled.
0013 Can not receive carrier signal within 6 sec. after sending CFR in data phase C.
0014 Can not receive T.30 signal after sending FTT signal.
0015 Line polarity change within receiving phase B to D.
0016 Receive DCN signal after sending PTT signal.
0017 Can not receive any response from remote side after sending type of xxx_EOM signal.
0018 Can not detect energy within 6 sec. after sending FTT command.
0019 Received DCN signal after sending CFR signal.
001A No energy on line over 6 sec. within phase C before any corrected ECM frame.
001D Detect flag but nothing after CFR.
0020 Can not correct frame within 6 sec., or in non-ECM mode, one decoding line over 6 sec.
0021 File full.
Owing to noise interference on the line, receiving side can't receive correct data within spec-
0022
ified time (no ECM).
002A Line Problem
0030 Did not receive any signal within 6 sec.at phase D.
0031 Received incorrect signal at phase D (not EOP, MPS, EOM, DCS PPS_Q, PPS_Q, etc.).
0032 Can not receive carrier within 6 sec. After sending MCF. Or RTP, RTN signal.
0033 Received DCN signal at phase D within pages (not last page).
In non-ECM mode, when machine already received the data but next line data doesn't
0039 receive within 13TX and RX machines both have different "machine ID (FAX model ID)"
code in RSD.
003F Remote side TSI not programmed in machine one touch or speed dial directory.
0040 Did not receive carrier signal within 6 sec. after sending CTR.
0041 Did not receive carrier signal within 6 sec. after sending PPR.
0042 Did not receive correct signal after sending RNR signal.
0043 Received incorrect signal at phase D in ECM mode.
0044 Did not receive carrier signal /FSK signal within 6 sec. after sending MCF in ECM mode.
0045 Did not receive any correct signal after sending RNR response with ERR signal.
0046 Receive incorrect signal when sending RNR response with ERR signal.
0047 Did not receive correct signal after sending ERR signal.
0048 Did not receive correct signal after receiving PPS_PRI_Q or PRI_Q, EOR_PRI_Q.
0049 Did not receive correct signal after sending PIP/PIN signal within 13 sec.
Possible Causes of Error.
18. FAX error
275