Waste Toner Near Full Detect Board/Led (Wtdtb/Led) - Konica Minolta magicolor 2490MF Service Manual

Field Service Ver. 1.0 Jul. 2006
[1]
[1]
[2]
[1]
5.3.16

Waste toner near full detect board/LED (WTDTB/LED)

[1]
[1]
4139F2C561DA
4139F2C546DA
4139F2C547DA
[2]
[3] [4]
4139fs2030c1
3. Remove four screws [1].
4. Disconnect two connectors [1] and
remove the high voltage unit [2].
Precautions for reinstallation of the
high voltage unit
• Make sure that the high voltage unit
fits into the tab [1] at the location
shown on the left.
• During the reinstallation proce-
dure, make sure that the high volt-
age terminal is not deformed or left
loose.
1. Remove the high voltage unit.
See P.42
2. Remove the screw [1], unhook the
tab [2], and remove the wiring saddle
[3]. Then, remove the shield [4].
NOTE
• When reinstalling the shield, use
care not to allow the harness to be
wedged in it.
5. Other
43